LED strip receiver EUROLITE 50531121 for single-color LED strips, wireless control interface

The EUROLITE 50531121 receiver for single-color LED strips is a compact wireless interface that enables remote control of one-color LED tape lighting. It connects between a single-color LED strip and its power source to accept wireless control signals for switching the strip on and off and adjusting fundamental lighting functions. The unit is intended for installations that require a small, unobtrusive receiver to add remote or centralized control to basic single-color LED lighting setups.

Advantages

The receiver offers a minimal footprint and straightforward wiring, making it easy to place inside profiles, behind fixtures, or in distribution boxes. Wireless signal reception simplifies retrofit projects by removing the need for additional cabling between the controller and the LED strip. Designed for single-color strips, the device supports reliable on/off switching and basic dimming where compatible with the connected controller, ensuring predictable behavior in residential or small commercial lighting applications.

Suitable for

Key specifications

How to use

Connect the receiver between the DC power supply and the single-color LED strip, observing correct polarity and ensuring the strip voltage matches the power supply and receiver specifications. Pair or set the receiver according to the instructions of the wireless controller or remote being used, then verify operation by switching the strip on and off and adjusting brightness if dimming is supported. Place the receiver in a location that allows reliable signal reception from the controller while avoiding excessive heat buildup.

Recommendations

Ensure the LED strip voltage and power rating are compatible with the receiver and power supply before installation. For stable wireless communication, install the receiver with minimal metallic obstruction between it and the controller, and keep the device in a ventilated area to prevent overheating. Follow local wiring regulations and disconnect power before making electrical connections.