Internal PC cable ShiverPeaks SCO 78246-0.5-Y3 50 cm straight metal spring

The ShiverPeaks SCO 78246-0.5-Y3 internal PC cable is a 50 cm straight connection cable with an integrated metal spring section designed for internal system wiring. It provides a fixed 50 cm length and straight connector orientation to simplify routing inside PC cases and small enclosures. The reinforced spring segment adds mechanical stability where connectors or cable runs may be subject to movement or pressure, while the straightforward geometry supports tidy cable management and clear signal or power paths.

Advantages

This internal PC cable combines a compact 50 cm length with a straight connector profile to reduce clutter and improve airflow within the case. The metal spring section increases durability at stress points and helps maintain connector alignment during installation or component changes. The cable’s design supports consistent signal or power transmission in internal configurations and is compatible with typical internal wiring layouts that require a reinforced segment for strain relief.

Suitable for

• Routing connections between motherboard headers and drive or accessory ports inside standard ATX, micro-ATX, or ITX cases
• Environments where a reinforced spring section is needed to reduce stress on connectors
• Tidy cable management in compact or crowded system builds
• Internal signal or low-voltage power routing in desktop PCs and small form-factor systems

Key specifications

• Length: 50 cm
• Connector orientation: straight
• Reinforcement: integrated metal spring section for mechanical stability
• Application: internal PC wiring for signal or low-voltage power routing
• Form factor: compact cable suitable for confined spaces inside PC cases

How to use

Identify the appropriate internal ports or headers on your motherboard and target devices, ensuring the straight connector orientation matches the available clearance. Route the cable along existing cable channels or behind the motherboard tray to maintain airflow and prevent interference with fans or moving parts. Position the metal spring section where additional strain relief is required—typically near connectors or bends—and secure the cable with cable ties or routing clips if needed. Avoid sharp bends that could exceed the cable’s designed radius and check connections after powering the system.

Recommendations

Use this cable for internal connections where a short, straight layout and added reinforcement improve reliability. Do not expose the metal spring section to conductive contact with other components. For best results, combine with standard cable management accessories and confirm connector compatibility before installation.