hole punch Gedore 570307

The Gedore 570307 hole punch is manufactured to DIN 7200 Form A and is intended for clean stamping of cardboard, leather, rubber, sealing materials and other soft materials. The cutting edge is hardened for longer life and the shaft features a blue varnish finish. The tool is supplied in a plastic wallet (item no. 570390).

Advantages

Hardened cutting edge provides consistent, precise holes and improved wear resistance. Conformance to DIN 7200 Form A ensures standardized hole dimensions and reliable performance. Blue-varnished shaft resists corrosion and simplifies handling. Supplied in a protective plastic wallet for safe storage and transport.

Suitable for

• Punching holes in cardboard and paper
• Working with leather and rubber materials
• Preparing seals and gasket materials
• DIY and light workshop tasks requiring precise circular holes

Key specifications

• Brand: Gedore
• Model / item: 570307 (supplied in plastic wallet no. 570390)
• Standards: DIN 7200 Form A
• Materials: suitable for cardboard, leather, rubber, sealing materials and other soft materials
• Cutting edge: hardened
• Shaft finish: blue varnish
• MPN: 2646382
• EAN: 4017981006170

How to use

Place the material on a firm, flat surface and position the hole punch at the desired location. Apply steady downward force on the punch handle until the hardened cutting edge penetrates the material and the waste slug is released. For thicker or tougher materials, support with a cutting board underneath and apply controlled, even pressure. After use, clear any trapped debris from the punch tube and store the tool in the supplied plastic wallet.

Recommendations

For optimal results, inspect the cutting edge regularly and sharpen or replace the punch if cuts become uneven. Use appropriate safety equipment, such as gloves and eye protection, when working with tougher materials. Avoid using the punch on materials harder than recommended to prevent damage to the cutting edge.