Fibre optic cable EFB Elektronik O1403.2 LC I-V(ZN) H 2 m Yellow

The EFB Elektronik O1403.2 LC I-V(ZN) H is a 2 m single‑mode fibre optic patch cable engineered for low-loss optical connections in communications and networking environments. It uses G.657.A2 fibre type with a 9 µm core diameter and LC connectors on both ends. The cable's yellow jacket provides clear visual identification in cable runs and distribution panels while meeting the I-V(ZN) H specification for indoor optical installations.

Advantages

This fibre optic cable offers consistent single‑mode performance with minimal attenuation due to its G.657.A2 fibre construction and 9 µm core. LC‑to‑LC connectors deliver a compact, reliable connection suitable for high‑density patch panels and equipment ports. The 2 m length balances reach and neatness in rack or wall‑mounted installations, and the yellow outer jacket simplifies routing and maintenance tasks.

Suitable for

• Patching between network switches and optical transceivers
• Interconnects in data centre racks and telecom cabinets
• Fiber backbone links in office and enterprise premises
• FTTx terminations and indoor distribution cabling

Key specifications

• Fibre type: G.657.A2 single‑mode
• Core diameter: 9 µm
• Cable length: 2 m
• Connector type: LC — LC (both ends)
• Jacket colour: Yellow
• Cable category: I‑V(ZN) H suitable for indoor installations

How to use

Inspect connector endfaces for cleanliness before installation and clean with appropriate fibre‑optic cleaning tools if required. Insert the LC connectors into corresponding LC ports on transceivers, switches, or patch panels until a positive latch is felt. Route the cable to avoid sharp bends or excessive tension; maintain the manufacturer's recommended minimum bend radius for G.657.A2 fibre. Secure the cable in cable management trays or on patch panels to prevent strain on connectors and ensure reliable long‑term performance.

Recommendations

Use this LC‑LC fibre cable for short indoor links where single‑mode performance and compact connectors are required. Regularly check connector endfaces and follow standard fibre‑optic handling procedures to maintain low insertion loss and high signal integrity.