Fibre optic cable BlueOptics MTP-4LC-S1M-BO 4x LC G.657.A1 1 m Green

The BlueOptics MTP-4LC-S1M-BO 4x LC G.657.A1 1 m Green is a 1-meter fibre optic assembly that connects an MTP multi-fiber interface to four LC terminations. Built with G.657.A1 single-mode fibre and a 9 µm core diameter, this cable is intended for high-density backbones, patching and interconnects where compact multi-fiber connectivity is required. The green jacket identifies the fibre type and helps maintain organized cabling in datacenter and telecom environments.

Advantages

This cable combines an MTP connector on one end with four LC connectors on the other to provide compact, high-density connections while reducing the number of separate fibres and connectors needed. The G.657.A1 fibre specification improves bend tolerance compared with older single-mode fibres, which reduces signal degradation in tight routing paths. A 9 µm core diameter supports standard single-mode transmission characteristics suitable for long-reach and high-speed links with low attenuation.

Suitable for

Key specifications

How to use

Install the MTP-4LC cable by inserting the MTP connector into the corresponding MTP port or cassette, ensuring correct alignment of keying and polarity. Route the cable to the target panel or device and plug the four LC connectors into the appropriate LC ports or adapters. Verify end-face cleanliness before mating and follow standard fibre handling practices to avoid excessive bending, pulling or contaminating connector end faces. Confirm link continuity and optical loss with appropriate test equipment after installation.

Recommendations

Before installation, inspect and clean connector end faces with approved fibre cleaning tools. Maintain bend radii above the minimum recommended for G.657.A1 fibre and secure the cable to prevent strain. Use this MTP-to-4×LC breakout for consolidating parallel optics connections or migrating from multi-fiber trunks to LC-based transceivers.