Fiber optic transceiver module BlueOptics SFP-10G-LR-SV-BO 10km SFP+

The BlueOptics SFP-10G-LR-SV-BO 10km SFP+ is a fiber optic transceiver module designed for 10GBASE-LR single-mode links up to 10,000 metres. Housed in an aluminium case and weighing approximately 20 grams, this SFP+ module uses an LC duplex connector and supports simultaneous transmit and receive operation over separate fibres. The module follows MSA-compliant form factor and interface conventions for wide interoperability with equipment that accepts 10G SFP+ LR optics and provides Digital Diagnostics Monitoring (DDM/DOM) capability when supported by host hardware.

Advantages

The module provides long-reach optical connectivity for 10 Gbps Ethernet and other high-speed optical protocols over single-mode fibre, enabling cost-effective extension of network links. Its compact SFP+ form factor and aluminium housing deliver a lightweight, durable solution for data centre switches, routers and other network appliances. Compliance with MSA and use of standard LC duplex optics permit straightforward replacement or upgrade of existing LR SFP+ ports while DDM support helps with remote monitoring and diagnostics.

Suitable for

Key specifications

How to use

Install the SFP-10G-LR-SV-BO into a compatible SFP+ port on your switch, router or storage device following the host device manufacturer’s hot-swap and insertion instructions. Use LC duplex single-mode patch cords to connect to the remote transceiver or patch panel; ensure transmit and receive fibres are crossed appropriately. Verify link status on the host device and, if available, read DDM/DOM diagnostic values via the management interface to confirm optical power, temperature and supply voltage are within expected ranges. Observe electrostatic discharge (ESD) precautions during handling and keep protective dust caps on the transceiver when not in use.

Recommendations

Use tested, single-mode LC patch cords and compatible host hardware that explicitly supports MSA-compliant 10GBASE-LR SFP+ optics to ensure interoperability. If you require remote monitoring, confirm the host equipment supports DDM/DOM to access diagnostic parameters. For reliable long-term operation, install the module in equipment with appropriate ventilation and avoid excessive bending of single-mode fibres to maintain optimal optical performance.