Fiber optic transceiver module BlueOptics Q2P64B-BO SFP28 100m Aluminium

The BlueOptics Q2P64B-BO SFP28 25GBASE-SR fiber optic transceiver module is designed for short-range, high-speed data transmission over multimode fiber. Constructed in an aluminium housing and weighing approximately 20 grams, the module uses an LC duplex connector and operates at 850 nm for both transmitter and receiver. It supports link lengths up to 100 meters and follows MSA SFP28 form-factor conventions for compatibility with SFP28 ports that accept 25GBASE-SR modules.

Advantages

This SFP28 transceiver provides 25 Gbps optical connectivity with low latency and immunity to electromagnetic interference inherent to fiber links. The aluminium casing offers mechanical durability and thermal stability while keeping the module lightweight. Digital diagnostics (DDM/DOM) support allows remote monitoring of parameters such as supply voltage, laser bias current, optical output and input power, and temperature when the host device supports these features. The module is tested for interoperability with hardware platforms that accept 25GBASE-SR SFP28 MSA-compatible modules.

Suitable for

Key specifications

How to use

Insert the BlueOptics Q2P64B-BO SFP28 module into a compatible SFP28 port according to the host device’s installation instructions, ensuring the LC duplex fiber patch cord is connected with correct transmit/receive orientation. Verify that the switch, router or server firmware accepts MSA-compatible SFP28 modules and enable DDM/DOM monitoring in the management interface if supported. After installation, check link status and data rate in the device management console and confirm optical power levels to ensure a healthy connection.

Recommendations

Use high-quality multimode fiber (OM3/OM4 as appropriate) and certified LC duplex patch cords for optimal reach and signal integrity. Ensure the host hardware supports 25GBASE-SR SFP28 modules and DDM/DOM if remote diagnostics are required. Protect transceiver endfaces from contamination by keeping dust caps on when not connected and follow standard electrostatic discharge (ESD) precautions during handling and installation.