Fiber optic transceiver module BlueOptics INE1053130-BO SFP LC Aluminium 20g

The BlueOptics INE1053130-BO SFP LC Aluminium 20g is a fiber optic transceiver module designed for reliable short-range multimode optical links. Compliant with MSA SFP form factor conventions, it provides 1000Base-SX performance with an 850 nm transmitter and receiver pair and an LC duplex connector. Constructed with an aluminium housing and weighing approximately 20 g, the module is intended for integration into switches, routers, storage systems and other network devices that support standard SFP optics.

Advantages

This SFP module supports Gigabit Ethernet and related high-speed protocols over multimode fiber to distances up to approximately 550 meters according to 1000Base-SX parameters. Manufactured to MSA guidelines, the unit incorporates quality optical and electronic components chosen to deliver long service life and stable optical performance. The LC duplex interface provides simultaneous send and receive channels, while the compact SFP form factor enables flexible deployment and easy hot-plug replacement in compatible hardware.

Suitable for

Key specifications

How to use

Install the module into an available SFP port on compatible network equipment until it latches firmly; no tools are required for insertion. Connect LC duplex multimode fiber patch cords to the module, ensuring correct transmit-to-receive alignment between link endpoints. Verify that the host device recognizes the module and that the link status indicates an active connection. If the host supports DDM/DOM, enable or query the diagnostic interface to monitor optical power, temperature and supply parameters for troubleshooting or preventive maintenance.

Recommendations

Use multimode fiber of appropriate grade (e.g., OM3/OM4 where applicable) and high-quality LC patch cords to achieve published reach and signal performance. Confirm compatibility with the specific network device firmware and enable digital diagnostics only if supported by the equipment. Handle the optical connector end-faces carefully and use dust caps when not connected to avoid contamination.