Fiber optic transceiver module BlueOptics AX-F0110-3P1SX-BO SFP+ LC Aluminium 20g

The BlueOptics AX-F0110-3P1SX-BO is a fiber optic SFP+ transceiver module designed for reliable 10G optical links. Built with an aluminium housing and an LC duplex interface, the module is intended for multimode fiber applications and supports short-range multimode transmission using 850 nm optics. The compact SFP+ form factor and a lightweight design (approx. 20 g) make it suitable for use in switches, routers and other network devices that accept SFP+ modules.

Advantages

This SFP+ transceiver follows MSA-compliant mechanical and optical specifications to ensure broad interoperability with compatible network equipment. The aluminium housing provides mechanical protection and thermal dissipation while keeping the module lightweight. The LC duplex connector and multimode 850 nm optics enable simultaneous transmit and receive channels on two fibers for full-duplex 10GBASE-SR links. The module is suitable for common short-range fibre runs up to typical multimode distances and supports digital diagnostics monitoring where the host hardware exposes that interface.

Suitable for

• 10 Gigabit Ethernet short-reach multimode links (10GBASE-SR)
• Interconnects between switches and routers in data centre racks
• Connections to storage systems and servers with SFP+ ports
• Patch panel to transceiver short-distance links within buildings

Key specifications

• Form factor: SFP+ (small form-factor pluggable)
• Connector type: LC duplex
• Optical wavelength: 850 nm (multimode)
• Supported data rate: up to 10 Gbit/s
• Typical application: 10GBASE-SR short-range multimode
• Material / colour: aluminium housing (aluminium colour)
• Weight: approx. 0.02 kg

How to use

Insert the BlueOptics AX-F0110-3P1SX-BO into an SFP+ slot of a compatible switch, router or server while the host device is powered off or following the manufacturer's hot-plug guidelines. Connect LC duplex multimode patch cords—observing correct transmit/receive orientation—to establish the optical link. Ensure the connected equipment is configured for 10G operation and that fibre type and patch cords match multimode requirements. If available on the host, enable or monitor the digital diagnostic interface to view parameters such as supply voltage, transmit power and receive power for link verification and troubleshooting.

Recommendations

Use high-quality multimode patch cables and maintain clean LC connector endfaces to ensure optimal optical performance. Verify host compatibility for 10GBASE-SR SFP+ modules and, where necessary, confirm that the device firmware supports third-party transceivers and digital diagnostics before deployment.