Fiber optic transceiver module BlueOptics AA1419049-E6 1250 Mbit/s SFP 1310 nm

The BlueOptics AA1419049-E6 1250 Mbit/s SFP 1310 nm is a single‑port fiber optic transceiver module designed for reliable point‑to‑point and switch-to-switch links in optical networks. It supports a data transfer rate of 1250 Mbit/s and transmits at a 1310 nm wavelength, providing a balance of reach and performance for metropolitan and enterprise network segments. The compact SFP form factor enables straightforward installation in SFP-compatible network equipment such as switches, routers and media converters.

Advantages

This BlueOptics transceiver offers stable data throughput at 1250 Mbit/s with a standardized SFP interface for broad compatibility. The 1310 nm wavelength provides lower dispersion over moderate distances while keeping insertion into standard single‑mode fiber simple. Its hot‑swappable SFP format allows maintenance or upgrades without powering down equipment, reducing downtime during network changes.

Suitable for

• Point‑to‑point fiber links between network switches
• Connection of routers and media converters to single‑mode fiber
• Edge and aggregation segments in metro and enterprise networks
• Replacement or upgrade of existing SFP transceivers operating at 1310 nm

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Nominal data rate: 1250 Mbit/s
• Wavelength: 1310 nm
• Fiber type: single‑mode fiber (typical for 1310 nm modules)
• Hot‑swappable: yes

How to use

Insert the BlueOptics SFP module into an SFP port on compatible network equipment until it clicks into place. Connect a single‑mode fiber cable to the module's optical connector, ensuring correct alignment and clean fiber end faces to minimize loss. Configure the network device as required for the link speed and optical interface; in many setups the module is recognized automatically and requires no additional configuration. For replacement, power down the device only if recommended by the equipment manufacturer, then remove the existing module and install the new one.

Recommendations

Use clean fiber connectors and certified single‑mode patch cables to maintain signal quality. Verify equipment compatibility with the SFP interface and 1310 nm wavelength before installation. Store unused modules in protective caps and dry conditions to prevent contamination.