Fiber optic transceiver module BlueOptics 37973029-BO 1250 Mbit/s SFP

The BlueOptics 37973029-BO 1250 Mbit/s SFP is a fiber optic transceiver module designed for compact SFP slots in networking equipment. It supports a maximum data transfer rate of 1250 Mbit/s and presents a silver metal housing with a lightweight build of approximately 20 g. The module follows standard SFP form factor dimensions and is intended for insertion into compatible switches, routers and transceivers to enable optical data links. Certified to CE, FCC and RoHS requirements and specified with an MTBF of 1,000,000 hours, the module is built to meet typical operational and regulatory expectations for network hardware.

Advantages

The BlueOptics SFP module provides a compact SFP form factor that fits standard hot-pluggable ports and supports full-rate 1250 Mbit/s optical transmission. Its metal casing and light weight contribute to simple handling and installation while meeting industry safety and environmental standards such as CE, FCC and RoHS. The stated MTBF of 1,000,000 hours indicates long-term reliability under normal operating conditions.

Suitable for

• Establishing single-mode or multimode fiber links where SFP transceivers are supported
• Upgrading or replacing optical interfaces in switches, routers and media converters
• Small to medium enterprise networks requiring 1.25 Gbps-class optical connections
• Field or datacenter deployments that require hot-pluggable SFP modules

Key specifications

• Form factor: SFP (hot-pluggable)
• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s class)
• Housing colour: Silver metal casing
• Weight: approximately 0.02 kg
• Reliability metric: MTBF 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Power down the target device or follow the vendor’s hot-swap procedures, then align the SFP module with the slot and insert until it clicks into place. Connect the appropriate fiber optic cable to the transceiver’s optical connector and secure any strain relief as required. After installation, verify link status and configuration on the host device; ensure transmit and receive settings, optics type and wavelength (where applicable) match the remote endpoint. To remove, disengage any latches and pull the module straight out following the device manufacturer’s guidance.

Recommendations

Use this BlueOptics 1250 Mbit/s SFP in equipment that explicitly supports third-party SFP modules and observe proper ESD handling when installing or removing the transceiver. Match fiber type and connector standard to the module and the connected equipment, and avoid bending fiber beyond manufacturer-recommended minimum bend radii to maintain link integrity.