Fiber optic transceiver module BlueOptics 02315176 10000 Mbit/s XFP 850 nm

The BlueOptics 02315176 10000 Mbit/s XFP 850 nm fiber optic transceiver module is designed for high-speed short-range optical links. It uses an XFP interface and supports a maximum data transfer rate of 10 Gbit/s at a nominal wavelength of 850 nm, providing a compact module suitable for integration into switches, routers and media converters that accept XFP form-factor modules. The module is intended for multimode fiber applications where reliable, low-latency data transmission is required.

Advantages

This XFP transceiver offers a standardized interface and a high data rate of 10000 Mbit/s while occupying a compact form factor. Operating at 850 nm makes it compatible with common multimode fiber infrastructures, and its specification supports interoperability with equipment that accepts XFP modules. The transceiver is engineered for consistent optical performance over short distances and for straightforward replacement or upgrade within existing network hardware.

Suitable for

• 10 Gbit/s short-range data links over multimode fiber
• Upgrading or replacing XFP-capable ports in switches and routers
• Data center interconnects and server-to-switch connections
• Media converters and modular optical line cards with XFP slots

Key specifications

• Interface type: XFP form factor compatible with XFP slots
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 850 nm for multimode fiber
• Typical application range: short-reach optical links (multimode)
• Form factor: hot-pluggable transceiver module

How to use

Install the BlueOptics XFP module into an empty XFP slot of compatible network equipment while the host device is powered down or following the manufacturer's hot-swap procedures. Connect appropriate multimode fiber patch cords (matching LC or other connector types supported by the equipment) to the module's optical interface, ensuring correct transmitter-to-receiver polarity. After installation, verify link status and interface settings on the host device and perform any required configuration for speed, duplex or optical diagnostics.

Recommendations

Use certified multimode fiber and quality patch cords to maintain signal integrity at 850 nm. Verify compatibility with the host device's XFP port and keep firmware and device drivers up to date. For optimal performance, observe recommended operating temperature and handling guidelines and avoid subjecting the optical connector faces to contamination; clean connectors before mating.