Fiber optic transceiver BlueOptics SF1G-LX3-BO QSFP-DD 1310 nm MPO-12

The BlueOptics SF1G-LX3-BO QSFP-DD 1310 nm MPO-12 is a fiber optic transceiver module designed for high-density, high-speed network environments. It uses a QSFP-DD interface and operates at a wavelength of 1310 nm with an MPO-12 optical connector. The module is lightweight (approximately 0.04 kg) and finished in a grey housing, making it easy to handle and install in compatible QSFP-DD ports for optical data transmission.

Advantages

The BlueOptics SF1G-LX3-BO provides a compact QSFP-DD form factor suitable for data center and carrier-class hardware that require high port density. Its MPO-12 connector supports multi-fiber parallel connections, simplifying cabling in dense installations. The 1310 nm operating wavelength is appropriate for single-mode fiber links over moderate distances while maintaining signal integrity. The module’s lightweight design and standard interface facilitate straightforward installation and replacement.

Suitable for

Key specifications

How to use

Install the BlueOptics SF1G-LX3-BO into a compatible QSFP-DD port following the host hardware manufacturer’s hot‑swap and handling procedures. Ensure the connected single-mode MPO-12 fiber trunk or breakout cable is rated for 1310 nm operation and that fiber connectors and patch panels are clean before mating. Confirm link settings and transceiver support in the switch or router firmware to enable the optical interface for carry of required network protocols.

Recommendations

For reliable performance, use single-mode fiber infrastructure rated for 1310 nm transmission, keep MPO-12 connectors clean and protected when not in use, and verify hardware compatibility with QSFP-DD modules in system documentation. Follow standard electrostatic discharge (ESD) precautions during handling and consult the network equipment vendor for any required configuration to enable the transceiver.