Fiber optic patch cable DELOCK 80151 MMF OM3 50 m 2x LC to 2x LC Aqua colour Full duplex

DELOCK 80151 is a 50 m multimode fiber optic patch cable with OM3 specification and a 50 µm core diameter. It provides full‑duplex data transmission via LC duplex connectors on each end (2x LC to 2x LC) and comes in an aqua jacket made from low smoke zero halogen (LSZH) material. The cable is designed for short‑reach, high‑speed links in data centres and network equipment interconnections.

Advantages

The OM3 multimode design supports higher bandwidth over short distances compared with lower multimode grades, while the 50 m length covers typical rack‑to‑rack and switch‑to‑switch connections. LC duplex connectors ensure compact, standardized terminations for modern networking equipment. The LSZH jacket reduces toxic smoke and corrosive gas emission in case of fire, which is suitable for indoor installations.

Suitable for

• Data centre patching and short‑reach links
• Switch‑to‑switch interconnects
• Connections to media converters and transceivers with LC ports
• High‑speed multimode networks up to OM3 performance ranges

When it may not be suitable

This cable is multimode OM3 with a 50 µm core and is intended for short‑reach applications; it is not designed for long‑haul single‑mode transmission or for networks requiring single‑mode fiber. It may not be suitable where different connector types (for example, SC or ST) or different fiber grades are required.

Key specifications

• Fiber type: Multimode (MMF), OM3
• Core diameter: 50 µm
• Length: 50 m
• Connectors: LC duplex to LC duplex (2x LC to 2x LC)
• Transmission: Full duplex multimode
• Jacket material: Low smoke zero halogen (LSZH)
• Colour: Aqua

How to use

Route the cable between the two devices ensuring bend radii are respected to avoid signal loss. Insert the LC duplex connectors into the corresponding LC ports on each device or patch panel until they click into place. Verify polarity and transceiver compatibility before powering the link, then test the connection with appropriate network testing tools or transceiver diagnostics.

What to consider before purchase

• Ensure your devices use LC connectors and support multimode OM3 fiber
• Confirm 50 m length is sufficient for your run and allows proper routing without excessive bends
• Check indoor LSZH jacket requirement for your installation environment

Recommendations

Use this OM3 LC duplex patch cable for short‑reach, high‑speed multimode links in racks and data centre environments; maintain minimum bend radius and handle connectors by the boot to preserve performance.