DMX splitter EUROLITE 70064826 8x RDM outputs

The EUROLITE DMX splitter 8x RDM outputs is a compact signal distribution device that takes a single DMX input and provides eight electrically isolated DMX outputs with RDM (Remote Device Management) support. It enables reliable distribution of control data across multiple lighting fixtures or control zones while preventing interference and ground loops. The unit is intended for fixed installations and portable use in theatres, clubs, event rigs and rental systems where stable DMX signal routing and remote addressing are required.

Advantages

The splitter offers eight isolated outputs to protect downstream devices from signal faults and to avoid address conflicts. Built-in RDM support allows remote configuration and status queries for compatible fixtures, simplifying setup and maintenance. Isolation on each output reduces the risk of ground loops and electrical noise affecting the DMX line, and the compact housing fits standard rack or flight-case installations. Overall the device increases system reliability and makes complex lighting topologies easier to manage.

Suitable for

Key specifications

How to use

Connect the incoming DMX signal from your controller or console to the DMX input on the splitter using a properly wired DMX cable. Distribute DMX cables from the eight isolated outputs to the respective lighting fixtures or downstream DMX devices. If fixtures support RDM, use an RDM-capable console or software to discover and configure addresses and parameters remotely. Ensure the splitter is powered according to the supplied power connection and follow standard DMX installation practices such as using correct cabling, termination at the end of each line where required, and maintaining proper cable routing to avoid interference.

Recommendations

For best results, use high-quality, DMX-rated cables and terminate the last device on each run with a DMX terminator. Keep power and DMX signal cables separated where possible to reduce electrical noise. When using RDM features, verify that connected fixtures and the console both support RDM to allow full bi-directional communication. Regularly inspect connectors and cable integrity to maintain reliable operation in permanent or rental installations.