BlueOptics XFP-10G-SR-DE-BO network transceiver module 10000 Mbit/s 850 nm

The BlueOptics XFP-10G-SR-DE-BO network transceiver module provides 10 Gbit/s optical connectivity for short-range multimode fiber links. The module uses an XFP interface and operates at an 850 nm wavelength with LC Duplex fiber connections. Compact and lightweight, it is designed for integration into compatible networking equipment that accepts XFP form-factor transceivers and is intended for high-speed Ethernet, Fibre Channel over Ethernet or SDH/SONET applications up to typical multimode distances.

Advantages

This XFP module supports a 10GBASE-SR optical standard for reliable short-range transmission over multimode fiber and implements industry MSA-compliant form factor and LC Duplex connectivity for straightforward installation. The 850 nm transmitter and receiver pair are optimized for multimode links, and the module's compact silver housing and low weight simplify handling and hot-swap installation. Built and tested to meet compatibility requirements, the transceiver includes digital diagnostic monitoring capability when supported by host hardware.

Suitable for

Key specifications

How to use

Insert the BlueOptics XFP-10G-SR-DE-BO into a compatible XFP slot on your switch, router or storage device following the equipment manufacturer's hot-swap instructions. Connect LC Duplex multimode fiber patch cords to the transmit and receive ports, ensuring correct polarity. Verify that the host device recognizes the transceiver and, if required, enable digital diagnostics in device management to monitor operational parameters such as supply voltage, laser bias current, optical output/input power and temperature. Perform link tests and verify negotiated link speed and status via the host's management interface.

Recommendations

Use multimode OM3/OM4 fiber patch cords for optimal 10G performance and stay within the specified short-range multimode distance. Ensure host equipment firmware supports third-party XFP modules and DDM if diagnostic monitoring is needed. Store and handle the module in ESD-safe conditions and keep dust caps on unused ports to preserve optical performance.