Transceiver CBO SPG-DR-LX-IDFC 1000Base-LX 1310nm fiber optic

The Transceiver CBO SPG-DR-LX-IDFC 1000Base-LX 1310nm fiber optic is a compact SFP module designed for gigabit Ethernet over single-mode fiber. It operates at a wavelength of 1310 nm and supports 1000Base-LX signaling to deliver reliable data transmission on extended-reach fiber links. The module fits standard SFP cages and provides a standardized electrical and optical interface for use in switches, routers and optical uplink ports, allowing straightforward replacement and interoperability with compatible equipment.

Advantages

This transceiver offers a compact form factor and compatibility with 1000Base-LX networks, enabling long-distance single-mode fiber connections without the need for additional media conversion. Built to industry interface standards, it ensures predictable performance and straightforward hot-swap replacement in supported devices. The optical wavelength and power characteristics are optimized for single-mode links, providing stable signal levels and minimal disruption when integrated into enterprise and carrier networks.

Suitable for

• Gigabit uplinks between switches and routers over single-mode fiber
• Optical backbone links in enterprise and carrier networks
• Data center interconnects and edge aggregation
• Upgrading copper ports to fiber-based 1000Base-LX connections

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Nominal data rate: 1 Gbps (1000Base-LX)
• Operating wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Connector type: compatible with LC fiber connectors
• Typical reach: designed for extended single-mode links (specific distance depends on fiber and system margins)
• Hot-pluggable: yes

How to use

Insert the SFP transceiver into a compatible SFP port on a switch, router or media converter with the module keyed and seated until it latches. Connect an LC-terminated single-mode fiber patch cable to the transceiver's optical port, observing correct transmit/receive alignment. Configure the network device as required for 1000Base-LX operation; most modern devices auto-negotiate the link at 1 Gbps when a compatible transceiver is detected. Monitor link status indicators on the host device and verify optical parameters with test equipment if required.

Recommendations

Use clean LC connectors and follow proper fiber handling practices to maintain optical performance. Ensure compatibility with the host device's transceiver requirements and firmware policies. For maximum reach, verify fiber type, attenuation, and connector quality; consult network design guidelines for link budgeting when deploying over long distances.