Transceiver CBO SFP-10G-BX-U Fiber Optic 10G 1310 nm

The BlueOptics Transceiver CBO SFP-10G-BX-U Fiber Optic 10G 1310 nm is a compact SFP+ module that supports 10 Gbps transmission at a 1310 nm wavelength. Designed for insertion into compatible SFP+ ports, this single-channel optical transceiver enables reliable uplinks and point-to-point connections in data centers, telecom environments and enterprise networks. The module follows standard SFP+ form factor dimensions for straightforward replacement and interoperability with a wide range of network equipment.

Advantages

This transceiver delivers 10 Gbps performance over single-mode fiber at 1310 nm, offering a balance between speed and reach for backbone and aggregation links. Its SFP+ form factor minimizes space usage in high-density switches and servers while providing hot-swappable convenience for maintenance and upgrades. The module is engineered for stable optical performance and consistent data throughput, reducing the need for frequent adjustments in typical network deployments.

Suitable for

• 10 Gbps uplinks between switches and aggregation layers
• Point-to-point fiber connections in data center racks
• Telecommunications backhaul and metro links over single-mode fiber
• Enterprise network backbone and server connectivity

Key specifications

• Optical interface: SFP+ form factor suitable for 10 Gbps ports
• Data rate: 10 Gbps (full duplex)
• Wavelength: 1310 nm (single-channel optical transmission)
• Fiber type: single-mode fiber (SMF)
• Connector type: LC duplex compatible
• Hot-swappable: yes
• Typical operating temperature range: industrial and commercial ranges depend on host equipment (refer to system specifications)

How to use

Install the transceiver by inserting it into a compatible SFP+ port on your switch, router or server until it clicks into place. Connect a single-mode fiber patch cable with LC connectors to the transmit and receive ports, observing correct polarity. After installation, verify link status and data rate through the host device management interface. For replacement, power down is generally not required due to hot-swap capability, but follow your equipment vendor's maintenance procedures to avoid service disruption.

Recommendations

Use high-quality single-mode fiber and properly seated LC connectors to maintain signal integrity. Ensure host equipment supports SFP+ modules and verify compatibility with device firmware if required. For longer link distances or specific environmental conditions, consult system documentation for recommended transceiver temperature ranges and link budget calculations.