Transceiver CBO SFP-10G-BX-U 10G 1310nm single-mode SFP+

CBO SFP-10G-BX-U is a 10G SFP+ transceiver module designed for single-mode fiber links operating at 1310 nm. Intended for high-speed uplinks, metro and access networks, this compact hot-pluggable module provides an optical interface for compatible switches and routers supporting 10 Gigabit Ethernet. The module implements a single-wavelength 1310 nm transmit/receive profile suitable for long-reach single-mode infrastructures where space-efficient SFP+ connectivity is required.

Advantages

The transceiver offers a small form factor SFP+ design that enables flexible deployment in systems with limited port density. Hot-pluggable capability allows replacement or upgrade without powering down the host device. Operating at 1310 nm on single-mode fiber supports longer link distances compared with multimode optics, while the 10G data rate meets typical requirements for uplink and aggregation roles. The module is compatible with standard 10 Gigabit Ethernet interfaces and designed for straightforward integration into existing network equipment that accepts SFP+ optical modules.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Metro and access fiber links over single-mode infrastructure
• Data center interconnects where 1310 nm single-mode optics are required
• Replacement or upgrade of SFP+ ports to enable 10G optical connectivity

Key specifications

• Form factor: SFP+ (small form-factor pluggable)
• Data rate: 10 Gbps
• Wavelength: 1310 nm (single-mode)
• Fiber type: Single-mode fiber (SMF)
• Optical interface: Duplex LC
• Hot-pluggable: Yes
• Application: 10 Gigabit Ethernet, optical uplinks

How to use

Install the transceiver into a compatible SFP+ slot on a switch or router until it seats and the module latches. Connect a single-mode duplex LC patch cable between the transceiver and the corresponding remote device port, ensuring correct polarity. Verify link status and speed through the host system management interface. For diagnostics, use the device management tools to read link and module status; follow the host vendor’s instructions for module compatibility and configuration.

Recommendations

Handle the optical connector caps and the transceiver carefully to avoid contamination. Inspect and clean fiber connectors before mating. Ensure the host device supports 10G SFP+ optics and verify module compatibility with the equipment vendor. Store unused modules in anti-static packaging and avoid exposing the optical interface to direct sunlight or dust.