Transceiver CBO SFP-10G-BX-D 10G Fiber Optic 1310nm

The Transceiver CBO SFP-10G-BX-D 10G Fiber Optic 1310nm is a compact, hot-pluggable SFP+ module designed for single-mode fiber links at 10 Gigabit speeds. Operating at a wavelength of 1310 nm, this BlueOptics-compatible transceiver is intended for high-speed network connections such as data center uplinks, carrier aggregation paths and enterprise backbone links. Its small form factor and industry-standard SFP+ interface simplify upgrades and replacements in compatible switches, routers and optical equipment.

Advantages

This 10G fiber optic transceiver offers stable 10 Gigabit throughput with low power consumption and reliable performance over single-mode fiber. The module's hot-pluggable design enables maintenance or upgrade without powering down the host device. Its single-wavelength 1310 nm operation ensures compatibility with point-to-point and wavelength-specific deployments in long-reach applications. The standardized SFP+ form factor promotes interoperability with a wide range of network hardware that supports SFP+ optical modules.

Suitable for

• Data center uplinks and server-to-switch connections
• Carrier and metropolitan area network (MAN) links
• Enterprise backbone and aggregation links
• Point-to-point single-mode fiber connections over medium to long distances

Key specifications

• Interface: SFP+ (hot-pluggable)
• Data rate: 10 Gigabit Ethernet (10 Gbps)
• Wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Connector type: LC duplex
• Typical power consumption: low (module-level)
• Compliance: industry-standard SFP+ mechanical and optical specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on the host switch, router or optical device until it latches. Connect single-mode LC duplex fiber cables, ensuring correct transmit and receive orientation. After physical installation, verify link status via the host device’s port indicators or management interface. If necessary, consult the network equipment’s documentation to confirm supported module types and enable the port. For safe removal, power down the port or follow the host device’s hot-swap procedure and gently release the module using the built-in latch.

Recommendations

Use quality single-mode fiber and clean LC connectors to maintain optical performance. Verify compatibility with the host device’s SFP+ specifications and firmware requirements before deployment. Avoid bending the fiber beyond recommended radius and protect the module from electrostatic discharge during handling.