Transceiver CBO SFP-10G-BX-D 10G Fiber Optic 1310nm

The Transceiver CBO SFP-10G-BX-D 10G Fiber Optic 1310nm is a small form-factor pluggable module designed for 10 Gigabit Ethernet links over single-mode fiber. Fitting standard SFP+ ports, this BlueOptics module operates at a wavelength of 1310 nm and supports high-speed data transmission for network devices such as switches and routers. Its compact design enables easy hot-plug installation into compatible SFP+ slots to extend or upgrade optical connectivity in data centers, telecoms and enterprise environments.

Advantages

This SFP+ transceiver offers stable 10G throughput with low power consumption and compatibility with SFP+ ports that accept vendor-neutral optics. The single-mode fiber design provides extended reach compared with multimode alternatives, and the 1310 nm wavelength is well suited for mid-range and long-reach links. The module’s compact SFP+ form factor simplifies integration into existing racks and devices, and its optical performance supports reliable transmission for high-bandwidth applications.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Data center server and storage interconnects over single-mode fiber
• Telecom access links and metropolitan area networks
• Network equipment upgrades where SFP+ 10G optics are required

Key specifications

• Form factor: SFP+ (pluggable)
• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Connector: LC duplex
• Typical reach: designed for mid to long-range single-mode links (device-dependent)
• Power consumption: low-power SFP+ class (device-dependent)

How to use

Install the transceiver into an available SFP+ port on a compatible switch, router or optical interface by aligning the module with the slot and pushing it in until it latches. Connect a single-mode LC duplex fiber cable with correct polarity between devices. Ensure the host device firmware and configuration allow third-party SFP+ optics if required, then verify link status and speed through the device management interface. Remove the module by releasing the latch and gently pulling it out; use protective caps for the transceiver and fiber connectors when not in use.

Recommendations

Use verified single-mode LC duplex cables and confirm compatibility with your network equipment. Keep fiber connectors clean and avoid bending the fiber beyond manufacturer-specified radii to maintain signal quality. For critical links, validate link performance after installation and monitor SFP+ temperature and status via the host device if supported.