Transceiver CBO AX-F0110-3Q1S Fiber Optic 25G

CBO AX-F0110-3Q1S Fiber Optic 25G is a compact fiber-optic transceiver designed to support 25 gigabit-per-second links for high-speed network environments. The module is intended for use in compatible switches and networking equipment to provide reliable 25G connectivity with low latency and high throughput. It is suitable for upgrading or expanding network links in data centers, aggregation layers and enterprise infrastructure where higher bandwidth per port is required.

Advantages

The transceiver offers a small form factor and straightforward installation to minimize rack space and simplify upgrades. It supports 25G data rate for links that require increased throughput compared with 10G modules, and is built to meet typical optical performance and interoperability requirements for modern network equipment. Its design focuses on stable signal transmission and predictable link behavior under standard operating conditions.

Suitable for

• Upgrading server and switch ports to 25G in data center top-of-rack and spine/leaf architectures
• High-throughput aggregation links between switches and routers
• Enterprise network segments requiring low-latency fiber connections
• Infrastructure expansion where compact transceiver modules are needed

Key specifications

• Data rate: 25 Gbps
• Form factor: compact fiber-optic transceiver module
• Interface: fiber optic connection for single-mode or multimode fiber (refer to equipment compatibility)
• Typical application: short to metro optical links and data center interconnects
• Compatibility: designed for use with switches and networking gear that accept standard 25G optical modules

How to use

Install the transceiver into an appropriate optical module slot on a compatible switch or network device following the device vendor’s hot-swap and installation procedures. Connect suitable fiber patch cables to the transceiver ports, ensure correct polarity and fiber type, then verify link status using the switch management interface or LED indicators. Monitor link performance and error counters after installation to confirm stable operation.

Recommendations

Use factory-tested fiber patch cables and follow the host device specifications for maximum reach and fiber type. Observe ESD precautions when handling the module, and verify interoperability with the target switch model and firmware to ensure proper link negotiation and performance.