SFP transceiver CBO SFP-10GD-LR-BO 10 Gbit/s single‑mode fiber, long‑reach

CBO SFP-10GD-LR-BO is an SFP optical transceiver module that supports 10 Gbit/s data rate over single‑mode fiber and is intended for long‑reach fiber links. The module provides a hot‑pluggable interface compatible with standard SFP cages on switches and routers, enabling reliable optical uplinks for data center interconnects, aggregation links and carrier networks. It is designed to upgrade compatible ports to 10 Gigabit Ethernet and to extend single‑mode fiber connections with a compact transceiver form factor.

Advantages

The transceiver offers a hot‑swappable design for easy installation and replacement without powering down equipment. It supports long‑reach single‑mode transmission, allowing longer fiber spans compared with multimode solutions. The module follows standard SFP mechanical and electrical specifications for broad compatibility with networking equipment that accepts SFP optical modules. Its compact size reduces space requirements in chassis-based systems while delivering 10 Gbit/s throughput for high‑capacity links.

Suitable for

Key specifications

How to use

Insert the module into a compatible SFP slot on the network device until it seats firmly and the retention latch engages. Connect single‑mode fiber patch cords to the transmit and receive ports, observing correct polarity. After insertion, verify link status on the switch or router and configure the interface for 10 Gbit/s operation as required by the host device. To remove the module, release the retention mechanism and pull the transceiver straight out; protect unused ports with dust caps when the module is removed.

Recommendations

Use single‑mode fiber and appropriate connectors for long‑reach links. Confirm host device compatibility with SFP optical modules and ensure firmware or port settings permit 10 Gbit/s SFP modules. Avoid excessive bending of fiber and protect transceiver optics from dust by replacing dust caps when not connected.