SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm single‑mode

SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm single‑mode is an optical module designed for 10 Gigabit Ethernet links over single‑mode fiber. It operates at a wavelength of 1310 nm and supports extended reach connections, providing a compact hot‑pluggable solution for switches, routers and optical equipment with SFP+ slots. The module is intended for environments where reliable long‑distance 10G connectivity is required while keeping port density and power consumption low.

Advantages

The SFP+ transceiver offers support for 10G data rates with low latency and stable transmission across single‑mode fiber. Its small form factor enables high port density in network equipment and hot‑swappable design simplifies installation and replacement without disrupting system operation. Built to comply with industry interface standards, the module delivers predictable performance for long‑reach links while maintaining compatibility with a wide range of network devices that accept SFP+ optics.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and core routers
• Long‑distance server and data center interconnects over single‑mode fiber
• Fiber links in metropolitan area networks (MAN) and campus backbones
• Optical equipment and transceiver slots requiring 1310 nm single‑mode 10G modules

Key specifications

• Data rate: 10 Gbps
• Operating wavelength: 1310 nm
• Fiber type: single‑mode
• Form factor: SFP+ (hot‑pluggable)
• Typical application: 10 Gigabit Ethernet over extended distances
• Interface: SFP+ electrical and LC optical connector

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch, router or optical device until it clicks into place. Connect the single‑mode fiber cable with an LC connector to the optical port, ensuring correct transmit/receive alignment. After physical installation, verify link status and configure the network device as required for 10G operation. For removal, power down or follow hot‑swap procedures recommended by the equipment vendor and gently withdraw the module using the latch mechanism.

Recommendations

Use certified single‑mode fiber and quality LC connectors to maintain signal integrity. Observe appropriate handling procedures to avoid contamination of the optical interface and follow the host device’s compatibility list to ensure reliable operation.