SFP+ transceiver CBO SFP-10G-BX-U-40KM-AN-BO 10 Gbit/s LC single-mode up to 40 km

CBO SFP-10G-BX-U-40KM-AN-BO is an SFP+ optical transceiver module that supports 10 Gbit/s data transmission over single-mode fiber with an LC connector. It is intended for compact, hot-pluggable installation in switches, routers and media converters to establish long-distance point-to-point links up to 40 km. The module is suitable for metro and campus network uplinks where stable, high-speed connectivity is required.

Advantages

The transceiver provides a standardized SFP+ form factor for easy hot-swap replacement and compatibility with many network devices. With single-mode operation and support for distances up to 40 km, it enables long-reach connections without additional repeaters. The LC interface and 10 Gbit/s throughput make it appropriate for backbone and aggregation links, offering predictable physical-layer performance and low-latency data transport.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Long-distance point-to-point fiber links in campus and metro networks
• Media converters and SFP+-capable line cards requiring LC single-mode modules
• Network redundancy paths and aggregation layers

Key specifications

• Data rate: 10 Gbit/s
• Fiber type: single-mode fiber (SMF)
• Connector: LC duplex
• Maximum reach: up to 40 km (dependent on fiber quality and link margin)
• Form factor: SFP+ hot-pluggable module
• Application: point-to-point and uplink fiber connections

How to use

Install the SFP+ transceiver into the appropriate SFP+ slot of a switch, router or media converter while the host device is powered according to the vendor’s hot-swap guidelines. Connect LC single-mode patch cords on transmit and receive ports following the link polarity. Verify link status and optical levels in the host device management interface. For reliable operation, observe device compatibility lists and confirm supported data rates and duplex settings in the networking equipment.

Recommendations

Ensure clean fiber connectors and adhere to ESD precautions when handling the module. Use single-mode patch cords with appropriate optical loss budget for distances up to 40 km, and check transceiver temperature and optical power reports during deployment to maintain stable links.