SFP+ Transceiver CBO SFP-10G-BX-U 10G 1310nm for single‑mode fiber

The BlueOptics SFP-10G-BX-U is an SFP+ transceiver module designed for single‑mode fiber networks, delivering 10 Gbps data rate over a 1310 nm transmit wavelength. The compact SFP+ form factor supports hot‑plug installation in compatible switches, routers and optical equipment, enabling high‑speed uplinks and long‑reach connections in data center and enterprise environments. This module is intended for use where reliable 10 Gigabit links over single‑mode fiber are required and fits standard SFP+ slots for easy integration and replacement.

Advantages

The transceiver provides a stable 10 Gbps throughput with optical transmission at 1310 nm, suitable for long‑distance links on single‑mode fiber. Its SFP+ form factor allows straightforward hot‑swap installation and reduces space usage in high‑density racks. The module is engineered for compatibility with common networking equipment and supports typical operational conditions for data center and campus deployments.

Suitable for

• 10 Gigabit uplinks between switches and aggregation devices
• Long‑reach single‑mode fiber connections in campus and metropolitan networks
• Server‑to‑switch and switch‑to‑switch links in data centers
• Optical equipment requiring SFP+ form factor modules

Key specifications

• Data rate: 10 Gbps
• Transmit wavelength: 1310 nm
• Fiber type: single‑mode fiber (SMF)
• Form factor: SFP+ (hot‑pluggable)
• Connector type: LC duplex (industry standard)
• Typical reach: suitable for long‑reach single‑mode links (network dependent)

How to use

Insert the SFP+ transceiver into an available SFP+ port on a compatible switch, router or optical device until it clicks in place. Connect LC duplex single‑mode fiber cables with correct polarity to the transmit and receive ports. Power on the host device and verify link status through the device management interface or LED indicators. For safe removal, disable the port if required by the host device, then press the release tab and gently pull the module out. Ensure fiber connectors are clean before installation to maintain signal quality.

Recommendations

Use with verified single‑mode fiber patch cables and maintain clean LC connectors. Confirm compatibility with the host device vendor’s supported transceiver list and check link settings (speed/duplex) after installation. Avoid exposure to excessive dust, moisture, or mechanical stress to preserve optical performance.