SFP Transceiver CBO M-SFP-LH-LC-EEC Fiber Optic 850nm/1310nm

CBO M-SFP-LH-LC-EEC Fiber Optic 850nm/1310nm is an SFP transceiver module from BlueOptics designed for network equipment with SFP slots. The module supports two optical wavelengths — 850 nm for short-range multimode links and 1310 nm for longer single-mode links — and uses LC duplex connectors for fiber connections. It offers hot-pluggable operation for easy installation and replacement without powering down connected devices, and is intended for creating reliable optical links between switches, routers and media converters.

Advantages

The transceiver supports both 850 nm and 1310 nm wavelengths in a compact SFP form factor, enabling flexible deployment across multimode and single-mode fiber links. Its LC duplex interface provides standardized connectivity while hot-swap capability simplifies maintenance and upgrades. Built to industry form-factor and optical specifications, the module integrates with a wide range of network devices and offers stable data transmission for short- and mid-range optical links.

Suitable for

• Connecting switches in data center and enterprise access layers over multimode or single-mode fiber
• Linking routers and media converters where LC duplex fiber interfaces are required
• Replacing or upgrading SFP ports to support both 850 nm and 1310 nm links

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Optical wavelengths: 850 nm and 1310 nm
• Connector type: LC duplex
• Application: short- and mid-range fiber optic links
• Hot-pluggable: yes

How to use

Insert the SFP transceiver into an available SFP slot on the network device until it latches, then connect LC duplex fiber patch cords to the module ensuring correct transmit/receive orientation. Verify link status through device LEDs or management interfaces and configure port settings if required by the host equipment. To remove, disengage the latch and withdraw the module; hot-swap capability allows this without powering down the device, although following device vendor guidance for insertion and removal is recommended.

Recommendations

Use appropriate fiber type (multimode for 850 nm and single-mode for 1310 nm) and matching cable grades to achieve expected reach and performance. Keep LC connectors clean and use dust caps when ports are not in use. Confirm compatibility with host device transceiver support lists and observe ESD precautions during handling and installation.