SFP+ transceiver CBO ALL4764 10Gbps multimode 850nm

CBO ALL4764 is an SFP+ fiber optic transceiver module engineered for 10Gbps data transmission over multimode fiber at an 850nm wavelength. The module follows the standard SFP+ form factor and supports hot-pluggable installation, making it suitable for short-range 10 Gigabit Ethernet links commonly used in data center top-of-rack, server-to-switch, and storage networking scenarios. The design focuses on compatibility with SFP+ ports and predictable optical performance for short-range multimode deployments.

Advantages

The transceiver provides a compact SFP+ form factor with 10Gbps line-rate performance over multimode fiber. Hot-pluggability allows replacement or upgrade without powering down equipment. Operating at 850nm, it is optimized for short-range links, offering reliable optical connectivity and straightforward integration into existing 10G Ethernet infrastructure. The module is suitable for high-density port environments due to its small size and standardized mechanical and electrical interfaces.

Suitable for

• Short-range 10 Gigabit Ethernet links in data centers
• Server-to-switch and switch-to-switch uplinks
• Storage area network (SAN) connectivity over multimode fiber
• Replacing or upgrading existing SFP+ transceivers

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 850 nm
• Fiber type: Multimode fiber (MMF)
• Form factor: SFP+
• Connector type: Duplex LC compatible
• Transmission distance: designed for short-range multimode links (typically up to the applicable MMF limit)
• Installation: Hot-pluggable

How to use

Insert the SFP+ transceiver into an available SFP+ port until it engages with the latch mechanism, then connect the duplex LC multimode fiber patch cable. Ensure both ends use compatible multimode fiber and that link settings on connected devices are configured for 10Gbps operation if manual configuration is required. Monitor link status through the host device interface and replace or reseat the module if link faults occur. Use appropriate ESD precautions when handling the module and keep optical ports covered when not in use to prevent contamination.

Recommendations

For reliable short-range 10G links, use OM3 or OM4 multimode fiber and quality duplex LC patch cables, verify transceiver compatibility with the host equipment, and perform end-to-end testing after installation to confirm link performance.