SFP+ Optical Transceiver CBO SFP-10G-C2M 10Gbps, 30 m

The SFP+ Optical Transceiver CBO SFP-10G-C2M is a compact, hot-pluggable module that delivers 10Gbps data transfer over multimode fiber for distances up to 30 meters. Designed for installation in compatible 10G SFP+ ports, this transceiver is suitable for short-reach fiber connections in network switches, routers and network interface cards. Its small form factor and industry-standard electrical and optical interfaces make it straightforward to integrate into existing 10GigE infrastructures where reliable, low-latency links are required.

Advantages

This SFP+ transceiver offers a reliable 10Gbps connection with short-reach optical characteristics tailored for multimode fiber. The hot-pluggable design enables quick replacement or upgrade without powering down equipment. The module’s standard SFP+ form factor ensures wide compatibility with switches, routers and server NICs that support 10G SFP+ ports. Low power consumption and an optical interface optimized for up to 30 m reduce cabling complexity in rack and data center environments.

Suitable for

• Data center uplinks between racks and switches
• Server-to-switch interconnects in short-distance deployments
• High-speed connections in campus or enterprise networks
• Upgrading 1G links to 10G where multimode fiber is available

Key specifications

• Data rate: 10 Gbps
• Reach: up to 30 meters over multimode fiber
• Form factor: SFP+ hot-pluggable module
• Interface: optical (short-reach multimode)
• Typical power consumption: low (module class typical for SFP+ optics)

How to use

Insert the SFP+ transceiver into an empty 10G SFP+ port on a compatible switch, router or network interface card until it clicks into place. Connect a suitable multimode fiber patch cable to the transceiver’s optical connector, ensuring correct end-face cleanliness and connector type. If required by the host device, verify link status and configure the port settings such as speed and duplex through the device management interface. To remove the module, disengage any latch mechanism and pull the transceiver straight out while the host is powered or following your equipment’s hot-swap procedure.

Recommendations

For optimal performance, use multimode fiber patch cables and keep connector end-faces clean. Match fiber type and connector standards used in your installation. Verify host compatibility with SFP+ short-reach optics and confirm link settings in device firmware or management software. Store unused modules in protective caps and anti-static packaging to prevent contamination and electrostatic damage.