SFP fiber transceiver CBO SFP-1G-EX 1 Gbps, LC connector, single-mode

The SFP fiber transceiver CBO SFP-1G-EX provides 1 Gbps optical connectivity over single-mode fiber using an LC connector. Designed for installation in SFP-compatible switches, routers and other network equipment, this hot-pluggable module supports long-distance links for Gigabit Ethernet or similar fiber-based protocols. The module is intended for network expansion, replacement of failed transceivers and integration into mixed vendor environments that support standard SFP optics.

Advantages

This transceiver offers a compact, hot-swappable form factor that simplifies upgrades and maintenance without powering down equipment. It delivers reliable single-mode performance for extended reach connections and uses a standard LC connector for broad compatibility. The module is interoperable with common Gigabit Ethernet ports and helps restore or extend fiber links quickly with minimal configuration.

Suitable for

• Establishing long-distance Gigabit Ethernet links over single-mode fiber
• Replacing defective or incompatible SFP modules in switches and routers
• Expanding fiber connectivity in data centers, telecom cabinets and campus networks
• Interoperable connections between mixed-vendor network equipment

Key specifications

• Data rate: 1 Gbps (Gigabit)
• Fiber type: single-mode
• Connector type: LC duplex
• Form factor: SFP (hot-pluggable)
• Optical link: designed for extended reach single-mode links
• Application: Gigabit Ethernet and compatible fiber protocols

How to use

Insert the SFP module into an available SFP port on a powered networking device until it seats securely; the module is hot-pluggable so most devices do not require shutdown. Connect single-mode fiber cables with LC connectors to the module, observing proper fiber handling and connector cleanliness to maintain signal quality. Verify link status on the host device and configure network settings as required for Gigabit Ethernet operation.

Recommendations

To ensure optimal performance, clean LC connectors before installation, avoid excessive fiber bend radii, and use compatible single-mode patch cords. Check the host device documentation for any vendor compatibility notes and confirm link parameters after installation. For critical links, test throughput and signal quality after deployment.