SFP Fiber Optic Transceiver CBO SFP-1G-LH 1G 1310nm

The SFP Fiber Optic Transceiver CBO SFP-1G-LH 1G 1310nm is a single-mode SFP module designed to provide 1 Gbps optical connectivity over long distances at a 1310 nm wavelength. This compact, hot-pluggable transceiver fits standard SFP slots in switches, routers and media converters, enabling fiber link extension for enterprise networks, data centers and service provider environments. The module uses an LC connector interface and supports low-latency data transfer suitable for backbone and aggregation links.

Advantages

This SFP transceiver delivers reliable long-haul single-mode performance with energy-efficient operation and a small form factor. Its hot-pluggable design allows installation or replacement without powering down the host device, minimizing downtime. The 1310 nm wavelength offers a balance between reach and dispersion characteristics for long-distance links, while the LC connector provides broad compatibility with existing fiber infrastructure. The module is engineered for stable throughput and compatibility with equipment that accepts standard SFP optics.

Suitable for

• Extending campus or metro fiber links between switches and routers
• Connecting media converters to single-mode fiber runs
• Backbone and aggregation links in enterprise and ISP networks
• Network upgrades requiring hot-pluggable 1 Gbps optical ports

Key specifications

• Data rate: 1 Gbps (full duplex)
• Optical wavelength: 1310 nm
• Fiber type: single-mode
• Connector type: LC duplex
• Form factor: SFP (hot-pluggable)
• Typical reach: long-distance single-mode links (manufacturer guidance applies)
• Operating mode: optical Tx/Rx for point-to-point links

How to use

Insert the SFP-1G-LH module into a compatible SFP slot on a powered network device, ensuring proper orientation until it clicks into place. Connect LC duplex single-mode fiber cables, observing correct transmit/receive alignment. After physical installation, verify link status via the host device interface and configure port settings as required for 1 Gbps operation. For safe removal, follow the device’s hot-swap procedure: disable the port in software if recommended, then gently release the module using the ejector mechanism.

Recommendations

Use single-mode fiber with appropriate attenuation and connectors; avoid excessive bending or tension on fiber runs. Confirm compatibility with the host device vendor’s supported optics list where necessary, and perform link tests after installation to verify signal integrity and throughput.