SFP fiber optic transceiver CBO SFP-1G-EX 1G single-mode 1 Gbps

CBO SFP-1G-EX is an SFP fiber optic transceiver supporting 1 Gbps data rate for single‑mode fiber links. Designed for network equipment with SFP slots, it offers a compact hot‑swappable module that enables fiber uplinks and point‑to‑point connections over extended distances. The module follows standard SFP form‑factor conventions for compatibility with switches, routers and media converters that accept SFP transceivers.

Advantages

The transceiver provides a reliable 1 Gbps optical interface with plug‑and‑play installation and low power consumption. Its single‑mode design supports long‑reach connections and stable signal performance, reducing the need for intermediate repeaters. Compatibility with standard SFP sockets ensures straightforward replacement or upgrade of copper ports to fiber without complex configuration.

Suitable for

• 1 Gbps uplinks between switches and routers over single‑mode fiber
• Long‑distance point‑to‑point fiber links in campus and carrier networks
• Optical uplink ports in access and aggregation switches
• Media converters and network devices that require SFP fiber transceivers

Key specifications

• Data rate: 1 Gbps (Gigabit Ethernet)
• Fiber type: single‑mode fiber
• Form factor: SFP (small form‑factor pluggable)
• Wavelength: compatible with standard long‑reach single‑mode wavelengths
• Interface: LC optical connector
• Operating temperature: suitable for typical indoor networking environments
• Power consumption: low, designed for efficient operation in rack devices

How to use

Insert the SFP module into an available SFP slot on the network device while the device is powered on or according to the equipment vendor guidance for hot‑swap. Connect a single‑mode fiber patch cable with LC connectors to the module and the remote device. The transceiver is recognized by standard networking hardware and typically requires no additional software configuration beyond usual port settings on the switch or router. Verify link status through device LEDs or management interface and ensure correct duplex and speed settings if manual configuration is necessary.

Recommendations

Use single‑mode fiber with appropriate LC duplex patch cords and maintain clean connector endfaces to ensure optimal optical performance. Confirm device compatibility and supported link distances with the network equipment documentation before deployment. For long‑haul installations, plan for fiber route protection and proper cable management to preserve signal integrity.