SFP+ Fiber Optic Transceiver CBO JNP-SFP-10G-BX10D-BO 10 Gbit/s 1330 nm

The SFP+ Fiber Optic Transceiver CBO JNP-SFP-10G-BX10D-BO is a compact 10 Gbit/s module that supports single-wavelength 1330 nm transmission. Designed for installation in compatible switches, routers and optical equipment, the SFP+ form factor allows hot-pluggable replacement and simplifies upgrades to 10 Gigabit Ethernet or other high-speed fiber links. The transceiver is intended for point-to-point fiber connections and fits standard SFP+ ports for straightforward integration into existing infrastructure.

Advantages

This transceiver offers a 10 Gbit/s data rate in a small SFP+ package, enabling high-density port deployment without significant space requirements. Operating at 1330 nm, it is suitable for short to medium range fiber links where this wavelength is supported. The hot-pluggable design reduces downtime during installation or maintenance, and the standardized form factor supports interoperability with many network devices that accept SFP+ modules.

Suitable for

• Upgrading switches and routers to 10 Gbit/s fiber links
• Establishing point-to-point Ethernet connections over single-mode fiber
• Replacing or maintaining existing SFP+ ports in data center or enterprise networks

Key specifications

• Data rate: 10 Gbit/s
• Wavelength: 1330 nm
• Form factor: SFP+
• Interface: fiber optic
• Mounting: hot-pluggable

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch, router or optical device until it clicks into place. Connect a matching fiber cable to the transceiver fiber port, ensuring correct connector type and polarity. Configure the network device as required for 10 Gbit/s operation and verify link status through device management tools or LEDs. For replacement, power down the device only if required by the vendor, then release the module and insert the new transceiver following the same steps.

Recommendations

Ensure compatibility with the target device and fiber type before installation. Use appropriate single-mode fiber and compatible connectors, and follow electrostatic discharge (ESD) precautions when handling the module. Verify firmware or vendor interoperability notes if available to prevent link negotiation issues.