SFP+ Fiber Optic Transceiver CBO FIM35032 10Gbps 850nm

The SFP+ Fiber Optic Transceiver CBO FIM35032 10Gbps 850nm is a compact, hot-pluggable module for short-range multimode fiber links. It supports 10 Gigabit Ethernet data rates over an 850 nm wavelength and is intended for insertion into compatible SFP+ ports on switches, servers and optical equipment. The small form factor and plug-and-play design make it suitable for rapid deployment and straightforward replacement in data center and enterprise network environments.

Advantages

This SFP+ transceiver delivers a stable 10 Gbps data rate with low power consumption and reliable short-reach performance on multimode fiber. Its hot-pluggable design simplifies maintenance and allows upgrades without powering down equipment. Built to industry form-factor standards, the module provides broad compatibility with SFP+ ports from many vendors and supports high-density uplink and server connection scenarios.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible SFP+ port on the network device until it seats securely. Connect the multimode fiber patch cable using the appropriate optical connector, ensuring clean endfaces and correct polarity. After insertion, verify link status and speed through the device management interface or status LEDs. For replacement, power down only if required by the device, remove the module by releasing the latch, and insert the new unit following the same procedure.

Recommendations

Use high-quality multimode fiber and clean connectors to ensure optimal optical performance. Verify compatibility with your switch or server vendor and check firmware or transceiver settings where applicable. Observe electrostatic discharge precautions during handling and store unused transceivers in protective packaging.