SFP+ Fiber Optic Transceiver CBO AA076004 for Dell Arista

The SFP+ Fiber Optic Transceiver CBO AA076004 for Dell Arista is a 10 Gigabit small form-factor pluggable module designed to provide high-speed optical connectivity in compatible Dell and Arista network equipment. This BlueOptics SFP+ transceiver fits SFP+ ports on switches and routers and enables reliable fibre links when used with matching cable type and connector standards. The module supports hot-swappable installation, allowing replacement or upgrade without powering down the host device, and is intended for environments that require stable, low-latency 10GbE optical connections.

Advantages

The transceiver offers 10Gbps data rate capability in a compact SFP+ form factor, ensuring compatibility with a wide range of enterprise and data centre switches that accept third-party modules. Hot-swappable design simplifies maintenance and installation. The module’s optical interface provides electrical isolation and immunity to electromagnetic interference compared with copper alternatives, supporting reliable long-term operation when used within its specified optical budget and link distance.

Suitable for

• Upgrading SFP+ ports on Dell and Arista switches and routers to 10 Gigabit optical links
• Replacing failed or aging SFP+ modules in enterprise networks
• Establishing short- or long-reach fiber connections between network devices (when matched with appropriate fiber type and transceiver specifications)
• Data centre uplinks and server-to-switch links requiring 10GbE bandwidth

Key specifications

• Form factor: SFP+ (10 Gigabit Small Form-Factor Pluggable Plus)
• Data rate: 10 Gbps
• Optical interface: fiber optic transmitter/receiver pair (single-mode or multi-mode depending on matched fiber and transceiver variant)
• Connector type: LC duplex (standard for SFP+ fiber modules)
• Hot-swappable: yes
• Operating environment: designed for rack-mounted and cabinet network equipment in enterprise and data centre environments

How to use

Insert the SFP+ transceiver gently into a compatible SFP+ port on a powered device until it clicks into place. Connect the appropriate LC duplex fiber cable between transceivers, ensuring the transmit and receive channels are correctly aligned and that the fiber type matches the transceiver’s specifications. The module is hot-swappable, so it can be installed or removed without shutting down the host device, but follow the host vendor’s guidance on interface enablement and configuration. After physical installation, verify link status and configure the network interface on the switch or router as required for speed, duplex, and any VLAN or trunk settings.

Recommendations

Use manufacturer-recommended fiber optic cable (single-mode or multi-mode) and keep connectors clean to maintain signal integrity. Verify compatibility with your specific Dell or Arista model and firmware level before deployment. For longer links, check the transceiver’s supported maximum distance and optical budget; for short-reach links, ensure multimode transceivers and OMx fiber are matched. Follow standard electrostatic discharge (ESD) precautions when handling the module and observe proper dust-cap use when the transceiver is not connected.