SFP+ Active Optical Cable CBO SFP-AOC-10G-20M 10Gbps 20m

The SFP+ Active Optical Cable CBO SFP-AOC-10G-20M 10Gbps 20m is a factory-terminated SFP+ direct-attach solution that provides a 10 Gbps full-duplex connection over a 20-metre multimode optical link. Designed for server, switch and storage interconnects, the cable integrates optical transceivers within the twin-terminated assembly to offer plug-and-play operation without separate modules. The compact SFP+ form-factor preserves port density while delivering low-latency, energy-efficient data transfer suitable for rack-to-rack links and campus backbone segments.

Advantages

This active optical cable eliminates the need for separate SFP+ transceivers, simplifying installation and inventory. The 20 m multimode link supports high-speed 10 Gbps throughput with low power consumption compared with equivalent copper solutions. With hot-pluggable SFP+ connectors and factory-polished optical terminations, the assembly offers consistent signal quality and reduced setup time in data centre environments. The integrated optics and standard SFP+ interface ensure broad compatibility with switches and servers that support SFP+ direct-attach optics.

Suitable for

• Rack-to-rack connections in data centres
• Switch-to-server links requiring 10 Gbps bandwidth
• Storage area network (SAN) uplinks and interconnects
• Campus backbone segments and aggregation layers
• Environments where compact SFP+ ports and fiber cabling are preferred

Key specifications

• Data rate: 10 Gbps full duplex
• Length: 20 metres
• Cable type: Active optical cable (multimode)
• Connector type: SFP+ on both ends (hot-pluggable)
• Link medium: Multimode optical fibre
• Latency: Low-latency optical transmission suitable for short-reach links
• Power: Integrated optical transceivers with lower power consumption than equivalent copper DACs

How to use

Install the SFP+ Active Optical Cable by inserting each SFP+ connector into the corresponding SFP+ port on network switches, servers or storage devices until it clicks into place. The cable is hot-pluggable; no separate transceiver modules are required. After physical connection, verify link status and speed on connected devices and configure network interfaces as needed. Use proper cable routing to avoid sharp bends and secure each end to prevent accidental removal.

Recommendations

For reliable performance, avoid bending the cable beyond the minimum bend radius specified by the manufacturer and keep connectors clean during installation. Use this 20 m AOC for short-reach multimode links within racks and between adjacent racks rather than long-haul or single-mode fibre runs. Confirm that connected equipment supports SFP+ active optical assemblies to ensure compatibility before deployment.