SFP+ Active Optical Cable CBO 10G 15m for compatible SFP+ ports (Zyxel-compatible)

The BlueOptics SFP+ Active Optical Cable CBO 10G 15m is a factory-terminated fiber link that provides a 10 Gbps duplex connection over a 15 meter optical cable for compatible SFP+ ports. Intended for short- to medium-reach interconnects, this AOC combines optical transmission with SFP+ form-factor simplicity to deliver low latency, lightweight cabling and immunity from electromagnetic interference. The cable is suitable for use in data centers, server rooms and network aggregation points where reliable 10 Gigabit links are required between switches, servers and storage systems.

Advantages

This AOC offers a stable 10 Gbps throughput with reduced signal degradation over the 15 m link compared with long copper runs. The integrated transceivers eliminate the need for separate fiber connectors or modules, simplifying installation and inventory. Lightweight fiber construction reduces rack strain and improves airflow in dense equipment environments. Optical transmission removes susceptibility to EMI and ground-loop issues commonly encountered with copper cabling.

Suitable for (tasks / use cases)

• Switch-to-switch aggregation links within racks or between adjacent racks
• Server-to-switch uplinks in data centers and server rooms
• Storage area network (SAN) interconnects and cluster connections
• High-density cabinet deployments where space and airflow are constrained

Key specifications

• Data rate: 10 Gbps (full duplex)
• Length: 15 meters
• Form factor: SFP+ active optical cable (factory-terminated duplex fiber)
• Connector type: SFP+ plug interfaces on both ends for compatible SFP+ ports
• Transmission medium: Optical fiber (AOC)
• Typical reach: short- to medium-reach interconnects (within data centers and server rooms)
• Latency: low propagation delay suitable for high-performance networking
• Electromagnetic immunity: not affected by EMI or ground-loop interference

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ port on the networking devices until the latch engages. Ensure both ends are seated in compatible SFP+ ports and that device firmware or operating system drivers support AOC modules. Verify link status through the device management interface and check for 10 Gbps link negotiation. Route the cable to avoid tight bends and maintain the minimum bend radius to preserve optical performance. No separate transceiver modules or fiber patch panels are required when using this factory-terminated AOC.

Recommendations

Handle the cable by the connector housings during insertion and removal, avoid kinking and maintain the manufacturer’s specified bend radius. Use AOC links in pairs of compatible SFP+ ports and confirm compatibility with the networking equipment vendor if active module interoperability is a concern. For best performance, keep the cable clear of sharp edges, excessive heat sources and strong electromagnetic fields despite AOC immunity to EMI.