SFP+ 10G Fiber Optic Transceiver CBO SFP-10G-BX-D (single-channel, 10Gbps)

CBO SFP-10G-BX-D is a single-channel SFP+ 10G fiber optic transceiver engineered for 10 Gigabit Ethernet links. The module offers a compact hot-pluggable interface for fiber connections in switches, routers and optical transport equipment. Designed for short- to medium-reach deployments, the transceiver supports 10Gbps data transfer and enables straightforward installation and upgrades for uplinks and interconnects without altering existing chassis or ports.

Advantages

The BlueOptics SFP+ transceiver delivers high-speed 10Gbps throughput in a small form factor with hot-pluggable convenience, reducing downtime during maintenance or upgrades. Its single-channel optical design provides stable, low-latency links suitable for aggregated uplinks and point-to-point connections. Compatibility with standard SFP+ slots and industry-compliant signal characteristics simplifies integration into a wide range of network devices.

Suitable for

• 10 Gigabit Ethernet uplinks between switches
• Interconnects in data center top-of-rack and end-of-row deployments
• High-speed links between routers and optical transport equipment
• Short- to medium-reach fiber runs requiring single-channel SFP+ modules

Key specifications

• Data rate: 10 Gbps
• Form factor: SFP+ (hot-pluggable)
• Optical channel: single-channel
• Reach: designed for short- to medium-reach fiber links
• Interface: duplex fiber connector compatible with single-channel optics
• Application: 10 Gigabit Ethernet and optical interconnects

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch, router or optical device until it clicks into place. Connect the appropriate single-mode or multimode fiber cable and secure connectors according to your device manufacturer’s instructions. Verify link status and speeds via the host device management interface and monitor optical power and link integrity. For replacement or upgrades, power-cycle is usually not required due to the hot-pluggable design, but follow equipment-specific procedures to avoid transient link issues.

Recommendations

Use factory-tested fiber cables and observe proper ESD handling when installing the module. Match fiber type and connector polarity to the network design, monitor transceiver optical power margins during commissioning, and consult switch/router vendor compatibility lists if vendor lock-in or firmware restrictions are a concern.