Optical SFP Transceiver CBO SFP-1G-LX 1G 1310nm Single-Mode

CBO SFP-1G-LX is a 1 Gbps optical SFP transceiver that operates at a wavelength of 1310 nm for use with single-mode fiber. The module provides a compact, hot-pluggable interface suitable for Ethernet uplinks, switches and routers and is intended to extend network reach over single-mode fiber links with reliable long-distance data transmission.

Advantages

The transceiver supports 1 Gbps data rates over single-mode fiber at 1310 nm, offering stable optical performance and low power consumption in a small SFP package. Its hot-pluggable design enables easy installation and replacement without powering down equipment, while industry-standard SFP compatibility ensures interoperability with a wide range of network devices. The form factor and optical characteristics make it suitable for point-to-point fiber connections and uplink ports in rack-mounted or compact network equipment.

Suitable for

• Ethernet uplinks between switches and routers over single-mode fiber
• Long-distance point-to-point fiber links in campus or data center environments
• Replacing or upgrading SFP ports in managed and unmanaged network devices
• Fiber connectivity for telecom and enterprise network segments

Key specifications

• Data rate: 1 Gbps (Gigabit Ethernet)
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP (small form-factor pluggable), hot-pluggable
• Interface: LC duplex optical connector
• Typical application: Ethernet uplinks and point-to-point links

How to use

Insert the SFP module into an available SFP slot on a compatible switch, router or media converter until it clicks into place. Connect single-mode fiber using LC duplex connectors, ensuring proper polarity. Verify device ports and link LEDs to confirm the transceiver is recognized and the optical link is established. Configure network settings on the host device as required for Gigabit Ethernet operation. For replacement, safely remove the module by depressing the release tab and pulling it out, then insert the new module following the same steps.

Recommendations

Use factory-quality single-mode fiber and LC connectors, maintain proper fiber cleanliness, and observe manufacturer guidelines for maximum link distance and power budgets to ensure reliable operation. Avoid excessive bending of fiber cables and protect the transceiver from electrostatic discharge during handling.