BlueOptics ONS-SE-GE-ZX-BO network transceiver module Fiber optic 1250 Mbit/s SFP

The BlueOptics ONS-SE-GE-ZX-BO network transceiver module is an SFP fiber optic transceiver designed for 1250 Mbit/s data transmission. Housed in a silver SFP form factor, the module implements 1000BASE-ZX optical signaling using LC duplex connections according to MSA standards. It provides both transmit and receive functions at 1550 nm and is intended for use in common networking hardware such as switches, routers, storage systems and measurement equipment. The module is CE, RoHS and FCC compliant and weighs approximately 20 g.

Advantages

The module follows MSA-compliant SFP specifications and is compatible with platforms that accept 1000BASE-ZX LC duplex SFPs, enabling straightforward replacement in supported hardware. It incorporates high-quality optical and electronic components designed to provide long service life and stable signal transmission. Integrated Digital Diagnostics Monitoring (DDM/DOM) provides real-time readouts of voltage, temperature, laser input/output power and bias current when supported by the host device, simplifying remote monitoring and troubleshooting.

Suitable for

Key specifications

How to use

Insert the SFP transceiver into a compatible SFP port on the host device until it clicks into place, then connect LC duplex fiber patch cables matching the module's polarity. Ensure the host device supports 1000BASE-ZX optics and, if DDM/DOM functionality is required, verify that the device firmware exposes diagnostic registers. Configure the network device as needed for the optical link (speed/duplex and interface settings) and monitor link status through the host management interface. For hot-pluggable use, follow the host vendor's guidance for safe insertion and removal to avoid port damage.

Recommendations

Use singlemode fiber with appropriate LC duplex patch cables for optimal range and signal quality. Verify compatibility with your network hardware and firmware before deployment and keep connectors clean to maintain low insertion loss. If remote diagnostics are needed, confirm that your host system supports DDM/DOM to access real-time telemetry.