InfiniBand active optical cable CBO QSFP-AOC-10M-CI-BO 10 m QSFP+ to QSFP+

CBO QSFP-AOC-10M-CI-BO is a 10 m active optical InfiniBand cable with QSFP+ connectors at both ends. It enables direct optical links between QSFP+ ports on switches, servers and storage nodes, providing a compact, plug-and-play solution for short-reach high-speed interconnects. The cable integrates active electronic components and multimode fiber to deliver low-latency, high-bandwidth data transmission without the need for separate transceivers or additional modules.

Advantages

The active optical construction ensures signal integrity over the full 10 m length while maintaining low power consumption and minimal latency. Using QSFP+ to QSFP+ connectivity simplifies installation and reduces rack cabling complexity. The cable's multimode optical design offers consistent performance in data center and HPC environments, with improved electromagnetic immunity compared with copper alternatives. Compact QSFP+ connectors reduce port density impact and enable straightforward hot-plug usage.

Suitable for

• Short-reach high-bandwidth links between switches in data center topologies
• Interconnects between servers and storage arrays in rack and row deployments
• High-performance computing (HPC) clusters requiring low-latency optical connections
• Aggregated uplinks and fabric connections where QSFP+ ports are available

Key specifications

• Connector type: QSFP+ to QSFP+
• Cable length: 10 meters
• Transmission medium: active multimode optical cable with integrated electronics
• Supported interface: InfiniBand / QSFP+ form factor
• Typical use: short-reach optical interconnects in data centers and HPC environments
• Latency: low-latency design suitable for high-performance fabrics

How to use

Install the cable by inserting each QSFP+ connector into the corresponding port on the equipment until the latch engages. Ensure ports are compatible with QSFP+ active optical links and check link status indicators on connected devices. No external transceivers or additional configuration is required in most deployments; device firmware or port settings may be verified for speed and lane configurations according to the host equipment documentation. Route the cable to avoid sharp bends and maintain the recommended bend radius for multimode fiber.

Recommendations

For reliable operation, use this active optical cable within supported temperature and humidity ranges and avoid tight cable bends or mechanical strain. Verify compatibility with switch and adapter firmware versions if vendor interoperability lists are required, and keep connectors clean and protected when not in use to maintain optical performance.