Fiber Optic Transceiver CBO SFP-1G-ZX 1G 1310nm SFP module

The BlueOptics Fiber Optic Transceiver CBO SFP-1G-ZX is a single-mode SFP module that supports 1 Gbps data transmission at a 1310 nm wavelength. Intended for long-distance fiber links, this compact SFP transceiver fits standard SFP ports in switches, routers and telecom equipment, enabling straightforward upgrades and maintenance without changing existing hardware racks or chassis. The module is engineered to provide stable optical links and compatibility with a wide range of network devices that accept SFP form-factor modules.

Advantages

This SFP module offers a small form factor that conserves space in networking equipment while delivering 1 Gbps throughput on single-mode fiber. Operating at 1310 nm, it is optimized for extended reach, maintaining signal integrity over long distances. The plug-and-play SFP design allows easy installation and replacement without specialized tools. The transceiver supports standard optical interface parameters to ensure interoperability with many switches and routers that accept SFP optics.

Suitable for

• Long-distance single-mode fiber links between buildings or data centers
• Gigabit uplinks in enterprise and carrier networks
• Upgrading or replacing SFP ports in switches, routers and optical line equipment
• Telecom and ISP access links requiring 1310 nm wavelength optics

Key specifications

• Data rate: 1 Gbps
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP (small form-factor pluggable)
• Typical application: long-reach optical links

How to use

Insert the SFP-1G-ZX module into an available SFP slot on a compatible switch, router or optical device until it clicks into place. Connect single-mode fiber patch cables with appropriate LC connectors to the transceiver ports, observing correct transmit/receive orientation. Power on the host device and verify link status through device LEDs or management interface. If necessary, configure the host port settings for 1 Gbps operation and confirm that any required optical parameters are matched on both ends of the link.

Recommendations

Ensure the transceiver is used with single-mode fiber and appropriate LC connectors. Verify compatibility with the host equipment’s SFP slot and, if applicable, confirm supported optics lists or firmware settings from the device manufacturer. Handle the optical ports and connectors with care to avoid contamination; use dust caps when the module is not connected. For reliable long-distance performance, use quality single-mode fiber and maintain correct polarity and connector cleanliness.