Fiber Optic Transceiver CBO GP-SFP-10GBX-D-40 10Gbps SFP+ for Single-Mode DWDM 40km

The CBO GP-SFP-10GBX-D-40 is a fiber optic SFP+ transceiver designed for 10Gbps data transmission over single-mode DWDM links up to 40 km. It is built for insertion in switches, routers and optical transport equipment where a hot-pluggable, compact 10Gbps module is required. The module supports Dense Wavelength Division Multiplexing (DWDM) operation and is suitable for metro, enterprise and carrier network deployments that need replaceable optical interfaces with reliable high-speed connectivity.

Advantages

This SFP+ transceiver provides a stable 10Gbps bitrate with DWDM compatibility for dense spectral deployments. Its hot-pluggable SFP+ form factor simplifies upgrades and replacements without powering down host equipment. The module’s single-mode optical design enables long-reach links up to 40 km, reducing the need for intermediate amplification in metro and regional links. The compact interface and standards-compliant electrical and optical characteristics ensure interoperability with common network switches and optical transport platforms.

Suitable for

• 10G Ethernet aggregation and distribution links in metro networks
• Carrier DWDM trunk lines and wavelength-enabled transport
• Enterprise campus backbone connections between buildings
• Upgrading SFP+ ports in switches and routers to support 10Gbps DWDM

Key specifications

• Data rate: 10 Gbps
• Optical mode: single-mode fiber
• Transmission technology: DWDM
• Maximum reach: up to 40 km
• Form factor: SFP+ hot-pluggable
• Connector type: LC duplex
• Typical power consumption: low-power SFP+ class

How to use

Install the transceiver into an available SFP+ port on a compatible switch, router or optical transport device while the host equipment is powered on, ensuring correct orientation until it clicks into place. Connect single-mode fiber patch cords with LC duplex connectors to the module, matching transmit and receive channels. Configure the host interface for 10Gbps operation and, if applicable, assign the proper DWDM wavelength and link parameters within the optical transport system. Monitor link status via the host device to verify successful optical connection.

Recommendations

Handle the fiber transceiver by the housing, avoid touching the optical interfaces and keep protective dust caps in place when not connected. Use clean LC connectors and follow standard fiber handling and ESD precautions. Verify compatibility with the host device’s SFP+ slot and, when deploying in DWDM systems, ensure wavelength planning and channel spacing comply with the network design.