Fiber optic transceiver CBO FN-TRAN-SFP+LR-BO 10 Gbit/s, single-mode, up to 10,000 m

CBO FN-TRAN-SFP+LR-BO is a fiber optic SFP+ transceiver designed for single-mode long-reach links and supporting a 10 Gbit/s data rate over distances up to 10,000 meters. The module is intended for use in network equipment with SFP+ ports and provides a standardized form factor for installation in switches, routers and optical transport devices. It delivers single-mode optical transmission suitable for uplinks, data center interconnects and campus backbone connections where extended reach and stable throughput are required.

Advantages

The transceiver supports up to 10 Gbit/s using a compact SFP+ form factor, enabling high-density deployment and straightforward compatibility with devices that accept SFP+ modules. Single-mode operation allows long-distance links up to 10,000 meters without intermediate electrical conversion, reducing latency and complexity in backbone paths. The module is built to the common optical interface standards for reliable plug-and-play operation in mixed-vendor environments.

Suitable for

• 10 Gbit/s uplinks between switches and routers in enterprise networks
• Data center interconnects across campus or between nearby facilities
• Campus backbone and fiber access links requiring long-reach single-mode optics
• Upgrading existing SFP+ ports to support long-distance fiber connections

Key specifications

• Data rate: 10 Gbit/s
• Optical mode: single-mode
• Maximum link distance: up to 10,000 meters
• Form factor: SFP+ (small form-factor pluggable plus)
• Typical application: long-reach uplinks and backbone connections

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your network device while the device is powered according to the equipment manufacturer's guidance. Connect a single-mode fiber cable with appropriate LC connectors to the transceiver's optical port, ensuring correct polarity. After physical installation, verify link status and negotiate the required 10 Gbit/s interface settings on your switch or router. If necessary, configure network interface parameters such as speed, duplex and optical diagnostics via the device management interface.

Recommendations

Use single-mode fiber with low-loss connectors and observe proper handling and cleaning procedures for fiber endfaces to maintain signal quality. Confirm that cable attenuation, patch panels and splices are within the link budget for distances approaching 10,000 meters. Use compatible SFP+ ports and follow vendor guidance for firmware or compatibility lists when integrating into heterogeneous network environments.