Fiber optic SFP transceiver CBO SFP-1G-LH 1 Gbps 1310 nm single-mode

Compact SFP fiber optic transceiver CBO SFP-1G-LH provides 1 Gbps full-duplex data transmission over single-mode fiber at a 1310 nm wavelength. The module is designed for hot-pluggable SFP slots in network switches, routers and media converters, enabling long-haul links and uplink connections. Its form factor and standardized electrical interface allow easy integration into existing network equipment to extend reach or replace faulty modules while maintaining optical performance suitable for backbone and point-to-point connections.

Advantages

The CBO SFP-1G-LH combines a small SFP form factor with long-reach single-mode optics, offering reliable 1 Gbps transmission and low power consumption. Hot-pluggable operation simplifies maintenance and upgrades without powering down equipment. Standardized behavior and optical parameters ensure interoperability with compatible single-mode transceivers and network ports, supporting stable, low-latency links for enterprise and carrier environments.

Suitable for

• Long-reach single-mode fiber uplinks between switches and routers
• Point-to-point optical connections in campus or metropolitan networks
• Replacing or upgrading SFP modules in managed or unmanaged network equipment
• Media converters and fiber extenders requiring 1310 nm single-mode interfaces

Key specifications

• Data rate: 1 Gbps (full-duplex)
• Optical wavelength: 1310 nm
• Fiber type: single-mode
• Connector type: LC duplex
• Form factor: SFP (small form-factor pluggable), hot-pluggable
• Typical reach: long-haul single-mode links (vendor-specified distance dependent on fiber and link budget)
• Power consumption: low-power SFP class (actual consumption depends on operating conditions)

How to use

Insert the transceiver into an available SFP slot on a compatible switch, router or media converter until it latches; no additional tools are required. Connect LC duplex single-mode patch cables, observing correct transmit/receive alignment. Configure the device port settings if required by the network equipment (speed/duplex, VLANs or optical diagnostics). Monitor link LEDs and management interfaces to verify optical link status and ensure proper signal levels and synchronization.

Recommendations

Handle the optical interfaces carefully: keep protective dust caps on when the transceiver is not in use, and clean connectors before mating. Use single-mode fiber and LC duplex patch cords rated for long-reach transmission, verify transceiver compatibility with the host device, and follow ESD precautions when handling modules. For critical links, confirm optical budget and test end-to-end performance after installation.