CBO Transceiver SFP-10G-BX-U 10G Fiber Optic 1310nm

The CBO Transceiver SFP-10G-BX-U 10G Fiber Optic 1310nm is a single‑module SFP transceiver designed for 10 Gigabit Ethernet links. Operating at a wavelength of 1310 nm, this compact SFP form factor module fits into compatible network switches and routers to extend fiber connections for high‑speed, low‑latency data transfer. The module supports hot‑swap replacement for minimal downtime and is suitable for use in data center and enterprise network environments that require reliable point‑to‑point fiber links.

Advantages

This 10G fiber optic transceiver provides a compact footprint and straightforward installation in SFP ports, enabling fast upgrades of existing network equipment without major hardware changes. The single‑wavelength operation at 1310 nm is optimized for reliable long‑reach transmission over single‑mode fiber, while the hot‑plug capability simplifies maintenance and replacement. The module’s compatibility with standard SFP cages and its focus on 10 Gigabit Ethernet protocols ensure predictable performance in modern network deployments.

Suitable for

• Point‑to‑point 10 Gigabit Ethernet links over single‑mode fiber
• Data center uplinks between switches and aggregation devices
• Enterprise campus backbone connections
• Network equipment requiring SFP form factor transceivers

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Data rate: 10 Gbps
• Operating wavelength: 1310 nm
• Fiber type: single‑mode fiber compatibility
• Connector type: LC duplex (standard for SFP fiber transceivers)
• Hot‑swap capable for tool‑free replacement

How to use

Install the transceiver into a compatible SFP port on a network switch or router, ensuring the module is fully seated in the cage. Connect the LC duplex single‑mode fiber cable to the transceiver, matching transmit and receive ends correctly. After insertion, verify link status in the network device’s management interface and confirm 10 Gbps operation. For safety, handle the fiber connectors with care and keep dust caps on when the module is not connected.

Recommendations

Use this transceiver with single‑mode fiber and LC duplex cables rated for 10G transmission. Check compatibility with your switch or router vendor to ensure firmware or hardware support for third‑party SFP modules. For optimal signal integrity, maintain clean fiber endfaces and follow standard fiber handling and installation practices.