CBO InfiniBand Active Optical Cable QSFP-AOC-30M-CP-BO — QSFP to QSFP, 30 m

The CBO InfiniBand Active Optical Cable QSFP-AOC-30M-CP-BO is a factory-terminated QSFP-to-QSFP optical link with a fixed 30 m length. Intended for data center and high-performance computing environments, this active optical cable delivers high-bandwidth, low-latency optical transmission between QSFP ports without the need for separate transceivers. The integrated optical engines and pre-terminated connectors simplify installation while maintaining signal integrity over a 30 metre reach.

Advantages

This active optical cable reduces installation time by providing a ready-to-use QSFP-to-QSFP connection and eliminates the requirement for separate pluggable modules at each end. The optical medium ensures low electromagnetic interference and supports long reach of 30 metres compared to copper alternatives. With a fixed length and factory-polished terminations, the cable offers predictable performance, stable signal quality and convenient rack-to-rack or row-level interconnect for switches and servers.

Suitable for

• Switch-to-switch connections in data centers
• Switch-to-server or switch-to-storage links requiring 30 m reach
• High-performance computing clusters using QSFP InfiniBand interfaces
• Rack-to-rack and row-level optical interconnects where low latency is required

Key specifications

• Connector type: QSFP to QSFP
• Cable type: Active optical cable (AOC)
• Nominal length: 30 metres
• Interface standard: InfiniBand-compatible QSFP optical link
• Transmission: Optical, low-latency, high-bandwidth
• Termination: Factory-terminated, fixed-length

How to use

Install the cable by inserting each QSFP connector into the corresponding QSFP port on the devices until the latch engages. Ensure both devices support InfiniBand QSFP interfaces and that firmware or operating system drivers are configured for the optical link. Route the cable through rack openings or cable management arms to avoid tight bends; observe the manufacturer’s minimum bend radius. Power on devices and verify link status through device LEDs or management interfaces to confirm active optical communication.

Recommendations

Store and handle the cable to avoid excessive bending, pulling or crushing. Use proper cable management to secure the 30 m run and maintain the minimum bend radius. Inspect connector end-faces before installation and keep protective caps on when not in use. For optimal performance, match supported data rates and QSFP port settings on connected equipment and consult device documentation when deploying in multi-vendor environments.