SFP+ AOC CBO 10G 7M for QNAP (SFP-AOC-10G-7M-QN-BO) active optical cable 10 Gigabit 7 m

Active Optical Cable (AOC) CBO SFP-AOC-10G-7M-QN-BO is a 10 Gigabit SFP+ direct-attach solution designed for QNAP-compatible SFP+ ports. At 7 meters length, the cable provides a single-cable connection that integrates transceivers and optical fiber, removing the need for separate fiber patch cords or discrete SFP+ modules. It is intended for high-speed server, switch and storage interconnects in data center and rack environments where reliable short-range 10G links are required.

Advantages

The BlueOptics AOC delivers low-latency 10G performance with reduced electromagnetic interference compared to copper alternatives and simplified installation through a plug-and-play SFP+ form factor. Its integrated optical design reduces connector points and cable management complexity while maintaining consistent data throughput for storage and network equipment. The 7 m length balances reach and manageable cable routing within racks and between adjacent rack rows.

Suitable for

• Interconnecting QNAP-compatible SFP+ ports on NAS devices and switches
• 10 Gigabit uplinks between servers and top-of-rack or aggregation switches
• Short-reach storage area network (SAN) and backup links
• High-density rack environments where compact, low-EMI cabling is required

Key specifications

• Data rate: 10 Gigabit Ethernet (10 Gbps)
• Form factor: SFP+ integrated active optical cable
• Length: 7 metres
• Connector type: SFP+ on both ends (hot-pluggable)
• Signal medium: Optical fiber with active transceiver electronics
• Typical latency: low, suitable for high-throughput links
• EMI characteristics: minimal radiated emissions compared to copper cables

How to use

Insert each SFP+ end of the Active Optical Cable into the corresponding SFP+ port on the QNAP device and the adjacent switch or server until it latches. Ensure both devices support 10G SFP+ links and are configured for matching link settings (speed and duplex where applicable). No separate transceivers or fiber patch cords are required. After insertion, verify link status and interface statistics in the device management interface to confirm a stable 10G connection.

Recommendations

Handle the cable by the connector housings and avoid tight bends or excessive tension on the optical assembly; maintain bend radius recommended for optical cables. Use in indoor rack and data center environments and verify compatibility with your QNAP device firmware and switch port vendor restrictions where applicable.