CBO InfiniBand Active Optical Cable QSFP-AOC-2M-MR-BO — 2 m

The CBO InfiniBand Active Optical Cable QSFP-AOC-2M-MR-BO — 2 m is an active optical cable engineered for high-speed data center interconnects using the QSFP form factor. At 2 meters in length, it provides an optical link between QSFP ports on servers, switches and storage systems. The cable supports low-latency, electrically passive optical transmission for short-reach links where consistent performance and QSFP AOC compatibility are required.

Advantages

This active optical cable combines the small QSFP connector profile with optical signaling to reduce electromagnetic interference and improve signal integrity over short distances. Its 2 m length simplifies rack-to-rack and within-rack routing while maintaining consistent throughput and low latency typical of InfiniBand environments. The cable’s construction reduces power consumption at the host interface compared to some active electrical options and provides a compact interconnect solution for dense equipment deployments.

Suitable for

• High-speed server-to-switch and switch-to-switch links within data centers
• Rack-to-rack and within-rack connections requiring QSFP AOC compatibility
• Low-latency InfiniBand clusters and compute/storage interconnects
• Environments where reduced EMI and improved signal integrity are needed

Key specifications

• Form factor: QSFP (quad small form-factor pluggable)
• Type: Active optical cable (AOC)
• Length: 2 meters
• Application: Short-reach data center links (within rack and rack-to-rack)
• Signal: Optical transmission designed for low latency and high throughput
• Compatibility: Designed for QSFP ports on servers, switches and storage devices

How to use

Install the cable by aligning the QSFP connector with the corresponding QSFP port and inserting until the latch engages, ensuring a secure connection at both ends. Use the cable for short-reach links between QSFP-equipped devices; avoid excessive bending near the connector and maintain the minimum bend radius recommended by the equipment manufacturer. If hot-plugging is supported by your hardware, connect or remove the cable while the systems are powered according to the host devices’ hot-swap guidelines.

Recommendations

Route the 2 m AOC to minimize sharp bends and mechanical strain, and avoid placing the cable near heat sources. Verify QSFP compatibility with your host devices and firmware versions before deployment. For optimal performance in InfiniBand setups, follow vendor guidelines for link configuration and monitor link status after installation.