Active Optical Cable (AOC) CBO 10G 2M for Juniper — SFP+ 10 Gigabit, 2 m

The BlueOptics Active Optical Cable (AOC) CBO 10G 2M for Juniper is a 2-metre, 10 Gigabit direct-attach solution designed for compatible SFP+ ports on Juniper networking equipment. The cable integrates twin optical fibers with compact SFP+ transceivers to provide plug-and-play connectivity for short-range links. Built for low latency and reduced power consumption compared with equivalent copper DACs, this AOC simplifies cabling, preserves signal integrity and supports high-throughput connections between switches, servers and storage systems.

Advantages

The AOC offers stable 10 Gigabit performance over a 2 m distance while eliminating the need for separate transceiver modules and patch cords. Its optical transmission reduces electromagnetic interference and ensures consistent signal quality in dense rack environments. The integrated SFP+ form factor supports hot-pluggable installation and automatic negotiation with compatible Juniper SFP+ ports, enabling fast deployment and straightforward maintenance.

Suitable for

• Inter-switch links in data center topologies
• Server to switch connections requiring 10 Gbps bandwidth
• Storage array uplinks and redundant pathways
• High-density rack installations where cable bulk must be minimized

Key specifications

• Data rate: 10 Gigabit Ethernet
• Length: 2 metres
• Connector / form factor: SFP+ integrated transceivers at both ends
• Transmission medium: twin optical fiber (active optical cable)
• Typical latency: low, suitable for latency-sensitive links
• Power consumption: lower than equivalent copper direct-attach cables
• Compatibility: designed for SFP+ ports on Juniper equipment

How to use

Install the cable by inserting each SFP+ end into the corresponding SFP+ port on the Juniper switch, server or storage device until the latch engages. Ensure both ends are seated securely and that connected devices are powered according to their vendor guidelines. The link should negotiate automatically at 10 Gbps when used with compatible equipment; verify link status through the network device's management interface. For removal, press the latch and gently withdraw the connector to avoid stress on the cable or port.

Recommendations

Keep the cable within its minimum bend radius and avoid sharp kinks; route it to prevent physical strain and to maintain optimal optical performance. Use the AOC for short-reach connections where 2 m length is sufficient and where reduced EMI and cable bulk are priorities. Confirm firmware and compatibility notes on Juniper devices if strict vendor locking or compatibility checks are enforced.